Installation Manual

ManualsBrandsK&N ManualsAutomotiveK&N 69-1206TP Typhoon Air Intake Kit, Complete Cold Air, Polished

TOOLS NEEDED:

NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE

MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.

1. Turn off the ignition and disconnect the negative

battery cable.

NOTE: Disconnecting the negative battery

cable erases pre-programmed electronic

memories. Write down all memory settings be-

fore disconnecting the negative battery cable.

Some radios will require an anti-theft code to

be entered after the battery is reconnected. The

anti-theft code is typically supplied with your

owner’s manual. In the event your vehicles’

anti-theft code cannot be recovered, contact an

authorized dealership to obtain your vehicles

anti-theft code.

TO START:

PARTS LIST:

Description Qty. Part #

WARNING: The K&N

Drycharger

included with this kit must be installed on the K&N

air lter when used with this K&N

cold air

intake system. The K&N

cold air intake system a performance product that can be used safely during mild weather conditions. During

harsh and inclement weather conditions, you must convert your cold air intake system to a short ram conguration, or return your ve-

hicle to the stock OEM airbox and intake tract conguration. Failure to follow these instructions can void your warranty.

™

10mm Socket

Extension

Flat Blade Screwdriver

Phillips Screwdriver

Pliers

Ratchet

HONDA

2003-06 Accord

L4-2.4L

NOTE: Excluding Accord SULEV LEV2

2003-2006 engine families 3HNXV02.4KCP,

4HNXV02.4KCV, 5HNXV02.4ECV, and

6HNXV02.4CMC

69-1206

A Hose Clamp #44 Stainless 5 08560

B Hose; 2-3/4”ID x 2”L, Blk. 1 08440

C Grommet 1 08283

D Throttle Body Tube 1 27158

E Hose Clamp # 020 Mini 2 08431

F Hose; 1-1/8”ID x 2”L, Blk. 1 084074

G Bracket; “Z” 1 010042

H Washer; 6MM Wave, SS 4 08277

I Bolt; M6-1.00 x 12MM, SS 1 07727

J Nut; 6MM Nylock, SS 3 07512

K Vibration Mount 2 07027

L Hose; 2-3/4”ID x 3”l Hump, Blk. 1 08439

M Cold Air Extension Tube 1 27160

N Air Filter 1 RU-4870

O Drycharger, Blk. 1 RX-4730DK

P Edge Trim; 18”L 1 102504

2. Remove the air temperature sensor from the

stock intake tube as shown.

3. Disconnect the vent from the stock intake tube

as shown.

4. Disconnect the crankcase vent hose from the

stock intake tube as shown.

5. Loosen the hose clamp at the throttle body and

remove the stock intake tube as shown.

6. Loosen the two air cleaner bolts as shown.

7. Unclip the wire harness from the bottom of the

air cleaner assembly as shown.

8. Remove the complete air cleaner assembly as

shown.

NOTE: K&N recommends that customers do

not discard factory air intake.

9. Remove the air inlet cover, which is secured to

the radiator core support by two plastic rivets.

Summary of content (3 pages)

PAGE 1
™ 69-1206 HONDA 2003-06 Accord L4-2.4L NOTE: Excluding Accord SULEV LEV2 2003-2006 engine families 3HNXV02.4KCP, 4HNXV02.4KCV, 5HNXV02.4ECV, and 6HNXV02.4CMC TOOLS NEEDED: 10mm Socket Extension Flat Blade Screwdriver Phillips Screwdriver Pliers Ratchet N PARTS LIST: A B C D E F G H Description Hose Clamp #44 Stainless Hose; 2-3/4”ID x 2”L, Blk. Grommet Throttle Body Tube Hose Clamp # 020 Mini Hose; 1-1/8”ID x 2”L, Blk. Bracket; “Z” Washer; 6MM Wave, SS Qty.
PAGE 2
Continued INSTALLATION INSTRUCTIONS 10. Remove the air inlet duct located directly in front of the battery. 11. Raise the vehicle up and support it with jack stands, then, remove the front tire as shown. 12. Remove the plastic rivets and screws that secure the inner fender valance, then, lower the inner fender valance down as shown. 13. Remove the two bolts that secure the resonator to the inner fender, then, remove the resonator at shown. 14.
PAGE 3
INSTALLATION INSTRUCTIONS Continued 32. Reverse the removal process and reinstall the inner fender valance. 33. Remount the tire and torque to factory specs. 30. Install the K&N® Drycharger® onto the K&N® air filter as shown. NOTE: Please be aware the Drycharger® is water repellent, not water proof. Depending on conditions and usage the water repellent treatment is good for 1 to 2 years. See the parts list to reorder a new Drycharger® if necessary. 36. The C.A.R.B.