Installation Manual

INSTALLATION INSTRUCTIONS
Continued
14. Install the silicone hose and hose clamps onto
the throttle body and tighten as shown.
15. Remove the crankcase vent chamber from the
stock intake tube as shown.
16. Install the rubber mounted stud into the
original air cleaner mount as shown.
17. Install the “Z” bracket onto the K&N
®
short ram
tube using the provided hardware as shown.
18. Install the provided grommet into the hole on
the K&N
®
short ram tube as shown.
19. Slide the K&N
®
short ram intake tube into the
silicone hose as shown.
20. Line up the bracket with the rubber mounted
stud and secure with the provided hardware but do
not tighten at this time.
27. Install the K&N
®
cold air tube from underneath
the vehicle as shown.
13. Remove the two bolts that secure the resonator
to the inner fender, then, remove the resonator at
shown.
10. Remove the air inlet duct located directly in
front of the battery.
11. Raise the vehicle up and support it with jack
stands, then, remove the front tire as shown.
12. Remove the plastic rivets and screws that se-
cure the inner fender valance, then, lower the inner
fender valance down as shown.
21. Install the air temperature sensor into the
grommet as shown.
22. Reconnect the vent hose to the vent on the
K&N
®
short ram tube as shown.
23. Install the provided hose and hose clamps onto
the stock crankcase vent chamber as shown.
24. Install the crankcase vent chamber onto the
vent on the K&N
®
short ram tube, then, connect the
other end to the crankcase vent hard line as shown
25. Install the silicone hump hose and hose clamps
onto the K&N
®
short ram tube as shown.
26. Install the provided rubber mounted stud onto
the front of the fender brace and secure with the
provided hardware as shown.
28. Slide the K&N
®
cold air tube through the hole in
the inner fender and slide the tube into the silicone
hump hose as shown. But do not tighten at this
time.
29. Line up the tube bracket with the rubber mount-
ed stud and secure with the provided hardware as
shown.