Installation Manual

INSTALLATION INSTRUCTIONS
Continued
10. Remove the bolt shown securing the intake
silencer to the inner fender; lift up to remove the
intake silencer from the vehicle.
11. Install the provided silicone hose (084016) onto
the throttle body and secure with the provided hose
clamp.
12. Install the two provided mounting studs onto
the heat shield using the provided hardware.
13. Install the provided rubber mounted stud
onto the heat shield as shown using the provided
hardware.
14. Cut the provided edge trim into three sections,
30” long, 10.5” long and 9” long.
15. Install the 9” and 10.5” sections of edge trim
onto the heat shield base as shown.
16. Set the heat shield base into position on the air
box mounts.
17. Place the provided fender washer onto the
fresh air intake scoop mount as shown.
18. Using the provided hardware, secure the
provided bracket (083161) to the fresh air intake
scoop mount and the rubber mounted stud on the
heat shield base.
NOTE: The provided fender washer from the
previous step should be placed between the
bracket and the fresh air intake scoop mount.
19. Install the provided rubber mounted studs onto
the heat shield as shown.
20. Loosen the hose clamp that secures the factory
intake tube to the mass air sensor housing and
then remove the hose from the mass air housing.
21. Remove the two bolts securing the mass air
sensor housing to the air box; separate the mass
air housing from the air box.
22. Secure the mass air sensor housing to the
rubber mounted studs on the heat shield as shown
using the provided hardware.
NOTE: The provided bolts will need to be
threaded through the holes in the mass air
sensor.
23. Install the provided hump hose (08421) onto
the mass air sensor as shown and secure with the
provided hose clamp.
24. Install the provided 1.0”OD grommet into the
K&N
®
intake tube as shown.
25. Install the 90° vent tting into the K&N
®
intake
tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
26. Install the K&N
®
intake tube completely into
the silicone hump hose and then set the complete
assembly onto the heat shield base.
27. Install the K&N
®
intake tube into the silicone
hose on the throttle body, then align the heat shield
and secure with the provided hardware. Align the
intake tube and secure with the provided hose
clamps.