User Manual

* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
INSTALLATION INSTRUCTIONS
Continued
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen
for air leaks or odd noises. For air leaks secure
hoses and connections. For odd noises, find cause
and repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N
Engineering, Inc., suggests checking the air
lter element periodically for excessive dirt build-
up. When the element becomes covered in dirt (or
once a year), service it according to the instructions
on the Recharger
®
service kit, part number 99-5050
or 99-5000.
ROAD TESTING:
22. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections.
Failure to follow the above instructions or proper
maintenance may void warranty.
20. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX 951-826-4001
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
10. Install the provided silicone hose (08698) onto
the lter adapter and secure with the provided hose
clamp.
11. Install the two provided mounting studs onto the
heat shield and secure with the provided hardware.
12. Install the K&N
®
air lter onto the lter adapter
and secure with the provided hose clamp.
13. Install the heat shield/lter assembly into the
vehicle so the mounting studs insert into the airbox
mounting grommets.
14. Install the provided fresh air scoop onto the
core support and then secure the scoop to the
core support and heat shield with the provided
hardware.
15. Install the provided silicone hump hose (08699)
onto the factory inlet tube as shown and secure
with the provided hose clamp.
16. Release the locking tab on the inlet air
temperature sensor and rotate counter clockwise to
remove it from the factory airbox.
17. Install the provided grommet and the inlet air
temperature sensor into the K&N
®
intake tube as
shown.
16a. Remove the grommet from the inlet air
temperature sensor as shown.
18. Install the K&N
®
intake tube into the silicone
hump hose and then into the lter adapter’s
silicone hose. Secure the intake tube with the
provided hose clamps.
19. Reconnect the inlet air temperature sensor
electrical connection.
18867G
3/21/17
21. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an
emissions inspector can see it when the vehicle
is required to be tested for emissions. California
requires testing every two years, other states may
vary.