Installation Manual

* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
INSTALLATION INSTRUCTIONS
Continued
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, nd cause and
repair before proceeding. This kit will function iden-
tically to the factory system except for being louder
and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., suggests checking the air
lter element periodically for excessive dirt build-
up. When the element becomes covered in dirt (or
once a year), service it according to the instructions
on the Recharger
®
service kit, part number 99-5050
or 99-5000.
ROAD TESTING:
20. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections. Failure
to follow the above instructions or proper mainte-
nance may void warranty.
19. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
11. Install the mass air sensor into the K&N
®
intake
tube and secure with the provided hardware.
12. Install the four provided 6mm studs into the
lter adapter as shown.
13. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
14. Assemble the tube, heat shield and lter adapt-
er along with a gasket on each side of the heat
shield, and secure with the provided hardware.
15. Loosen the hose clamp securing the intake
elbow to the throttle body so that the intake elbow
position can be adjusted.
16. Install the intake assembly into the factory in-
take elbow and align the heat shield with the rubber
mounted studs installed onto the mounting bracket.
Align the intake for proper t and secure with the
hardware provided and factory hose clamps.
17. Install the K&N
®
air lter onto the lter adapter
and secure with the provided hose clamp.
18. Connect the mass air sensor electrical connec-
tion.
18973B
8/29/13
10. Remove the two screws that secure the mass
air sensor to the factory airbox and then remove
the mass air sensor from the airbox.