Installation Manual

INSTALLATION INSTRUCTIONS
Continued
7. Install the heat shield mounting bracket
#(083172) onto the heat shield as shown using the
provided hardware.
8. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
9. Apply several drops of the provided “Super Glue”
to the lip of the venturi as shown.
10. Install the venturi into the K&N
®
intake tube
so that the hole lines up with the mass air sensor
adapter.
NOTE: Some tapping may be needed to fully
seat the venturi into the intake tube.
11. Remove the two screws securing the mass air
sensor into the factory air box and then remove the
mass air sensor from the air.
18a. On vehicles equipped with air injection,
release the clamp securing the factory air injection
tting to the hose and then remove the tting from
the hose.
12. Install the mass air sensor into the K&N
®
intake
tube and secure with the provided hardware.
13. Remove the rear engine mounting bolt shown.
NOTE: This bolt will be reused.
14. Install the K&N
®
intake tube into the silicone
hose but do not completely tighten at this time.
15. Set the Heat shield assembly along with the
provided spacer onto the engine mount and secure
with the engine mounting bolt removed in step #13.
16. Install the tube mounting bracket (010051) onto
the heat shield along with the provided spacer.
Align the tube and heat shield for proper t and
then secure the bracket, heat shield and intake
tube with the provided hardware.
17. Install the K&N
®
air lter onto the intake tube
and secure with the provided hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RX-4990DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.
18. Reconnect the mass air sensor electrical
connection.
6. Install the silicone hose (084016) onto the
throttle body and secure with the provided hose
clamp.
18b. On vehicles equipped with air injection, install
the provided breather lter onto the factory tting
from step #11a as shown and secure with the
provided hose clamp.
18c. On vehicles equipped with air injection, install
the breather assembly onto the air injection pump
as shown.