Installation Manual

INSTALLATION INSTRUCTIONS
Continued
7. Install the provided 90º elbow hose (08504) onto
the turbo inlet and secure with the provided hose
clamp.
NOTE: Do not completely tighten at this time.
8. Install the provided 90º and straight vent ttings
into the K&N
®
intake tube as shown.
9. Set the K&N
®
intake tube into position in the
silicone hose; do not completely tighten the hose
clamp at this time.
10. Install the two ½” high rubber mounted studs
provided into the air box mount bolt locations.
11. Install the provided 1” high rubber mounted
stud into the heat shield mounting stud.
12. Install the heat shield mounting stud onto the
heat shield as shown using the provided hardware.
13. Install the air lter adapter into the heat shield
and secure with the provided hardware.
14. Cut the provided edge trim into two sections
as shown. One section is to be 39” long and one
section will be 3” long.
15. Install the edge trim onto the heat shield as
shown
16. Slide the silicone hose (08699) onto the intake
tube all the way on. Do not tighten at this time.
17. Set the heat shield into position on the rubber
mounted studs and secure with the provided
hardware.
18. Align the intake tube with the lter adapter and
slide the silicone hose onto the adapter. Tighten all
of the hose clamps for the upper and lower silicone
hoses securing the intake tube.
19. Connect the Blow of valve hose, EVAP hose
and crank case vent hose to the intake tube and
secure with the provided hose clamps.
20. Install the K&N
®
air lter and secure with the
provided hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RF-1048DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.
21. Reinstall the fresh air intake scoop and secure
with the factory hardware.