Installation Manual

INSTALLATION INSTRUCTIONS
Continued
7. Remove the three bolts securing the air lter
housing assembly and then lift up and remove the
air lter housing assembly from the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
8. Remove the small cover that is installed onto the
hose clamp screw securing the intercooler charge
hose, then loosen the hose clamp and disconnect
the charge hose from the throttle body inlet.
NOTE: A small screw driver will be helpful to
pry the cover off of the hose clamp screw.
9. Remove the two upper throttle body mounting
bolts shown.
NOTE: These bolts will be reused in the next
step.
10. Install the provided tube mounting bracket
(064303) onto the throttle body and secure with the
factory bolts from the previous step.
11. Reinstall the inlet charge hose onto the throttle
body and secure with the factory hose clamp.
12. Install the heat shield mounting bracket
(070015) onto the heat shield and secure with the
provided hardware.
13. Cut the provided edge trim into four sections,
One section will be 26.5” long, one section will be
21” long, one section will be 11.5” long and the nal
section will be 5” long.
14. Install the three section of edge trim onto the
heat shield as shown.
15. Set the provided rubber fender washer onto the
air box mounting location on the inner fender as
shown.
16. Install the heat shield assembly and secure
it the two air box mounting locations with the
provided hardware as shown.
17. Install the provided silicone hose (08096)
onto the turbo inlet as shown and secure with the
provided hose clamp.
18. Install the provided Vent tting into the K&N
®
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
19. Install the K&N
®
intake tube into the silicone
hose and align with the mounting bracket. Secure
the tube with the hose clamp and hardware
provided.
20. Cut the provided 90° air injection hose as
shown. The hose should be 3” long.
21. Install the provided hose mender into the 90°
air injection hose and secure with the provided
hose clamp.