Installation Manual
69-8618
NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED
HARDWARE MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery
cable erases pre-programmed electronic
memories. Write down all memory settings
before disconnecting the negative battery cable.
Some radios will require an anti-theft code to
be entered after the battery is reconnected. The
anti-theft code is typically supplied with your
owner’s manual. In the event your vehicles’
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles
anti-theft code.
TO START:
™
TOOLS NEEDED:
TOYOTA
2012-14 Camry
V6-3.5L
2. Lift up the engine cover and remove it from the
vehicle.
3. Disconnect the vacuum line shown from the
intake plenum.
4. Disconnect the crank case vent hose from the
intake tube.
5. Loosen the hose clamp securing the intake tube
to the throttle body.
6. Disconnect the mass air sensor electrical
connection and then unhook the wiring harness
from the air box.
at blade screw driver
Phillips screw driver
ratchet, extension
10mm socket
8mm socket
9/16” socket
10mm wrench
3mm wrench.
PARTS LIST:
Description Qty. Part #
A Hose Clamp # 48 1 08601
B Hose; 3-1/8” To 3”ID X 2”L Reinforced 1 084031
C Hose Clamp # 44 Stainless 1 08560
D Hose; 4MM ID X 18”L 1 08153
E Rubber Hose; 4MM ID X 12”L 1 08147
F Intake Tube 1 27528TS
G Cap; Rubber 5/16”OD X 5/32”ID X 11/16”H 3 08282
H Bolt; M4-0.07 8MM, A/H Cap, SS 2 07733
I Bracket; “L”, 69-8611, STL, TB/PC 1 06485
J Washer; 1/4”ID X 5/8” OD -SAE 6 08275
K Washer; M6 Split Lock Zinc 4 1-3025
L Bolt; 6MM-1.00 X 16MM, SS 5 07812
Description Qty. Part #
X
W
M
M
M
Q
I
F
C
B
E
D
A
T
J
J
L
K
R
S
H
M
N
G
O
P
J
L
J
K
L
J
K
L
L
V
U
M Edge Trim; (70”) 1 102454
N Bracket; 69-2521, “L”, SML, STL, TB/PC 1 070066
O Washer; 5MM Internal Star Cut Lock 1 07724
P Bolt; M5 X .8 X 8MM, Buttonhead, SS 1 07740
Q Heat Shield 1 07392
R Bolt; 3/8”-16 X 1-1/4”L SS Hex Head Bolt 1 07779
S Washer; 3/8” Flat Washer, SS 1 08134
T Insert; 3/8-16 X 3/400 X 15/16L, Rubber 1 08163
U Nut; 6MM Nylock, Hexhead SS 1 07512
V Bracket; 57-3021, L-Bend, Fin, TB/PC 1 070812
W Hose Clamp # 52 1 08610
X Air Filter 1 RU-4990