Installation Manual

INSTALLATION INSTRUCTIONS
Continued
7. Disconnect the vacuum line from the union tting
shown leaving the union installed into the vacuum
line attached to the vehicle.
8. Disconnect the vacuum line at the TEE tting
shown.
9. Remove the vacuum hose shown from the TEE
tting and vacuum switching valve.
10. Disconnect the lower vacuum hose from the
vacuum switching valve.
11. Remove the 7 clips securing the upper valance
and then remove the upper valance from the
vehicle.
12. Disconnect the vacuum switch electrical
connection and then unhook the harness from the
fresh air duct.
13. Remove the two bolts securing the fresh air
duct and then remove the fresh air duct from the
vehicle.
14. Remove the two blots shown securing the air
box.
15. Remove the air box from the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
16. Remove the air box mounting grommet shown.
17. Install the heat shield mounting bracket
(070066) onto the heat shield using the provided
hardware.
NOTE: The slotted end of the bracket attaches
to the heat shield.
18. Install the heat shield mounting bracket
(070812) onto the heat shield using the provided
hardware.
NOTE: Do not completely tighten at this time.
19. Cut the provided edge trim into three sections,
the long section is 47” long, the medium section is
14-1/2” long, the short section is 7” long.
20. Install the 47” long section of edge trim onto the
heat shield as shown.
21. Install the 14.5” length edge trim into the hole of
the heat shield as shown.