Installation Manual

INSTALLATION INSTRUCTIONS
Continued
22. Install the 7” section of edge trim onto the heat
shield as shown.
23. Remove the vacuum switching valve from the
air box as shown.
24. Secure the vacuum switching valve to the “L”
installed onto the heat shield as shown and then
install the provided vacuum caps.
25. Install the provided inserted nut into the heat
shield mounting bracket location.
26. Set the heat shield into position and secure
with the provided hardware.
27. Remove the front lower throttle body mounting
bolt shown.
NOTE: This bolt will be reused in the next step.
28. Install the tube mounting bracket (06485) onto
the throttle body securing with the factory bolt
removed in the previous step.
NOTE: Do not completely tighten at this time.
29. Install the silicone hose #084031 onto the
throttle body and secure with the provided hose
clamp.
30. Remove the two screws securing the mass air
sensor and then remove the mass air sensor from
the factory air box.
31. Install the mass air sensor into the K&N
®
intake
tube and secure with the provided hardware.
32. Install the K&N
®
intake tube into the silicone
hose at the throttle body and align with the tube
mounting bracket. Align the tube and bracket
for proper t and then secure with the provided
hardware and hose clamp.
33. Connect the crank case vent hose to the K&N
®
intake tube and secure with the factory clamp.
34. Reinstall the fresh air intake scoop and secure
with the factory hardware.
35. Install the provided vacuum plug onto the
vacuum TEE.
36. Install the provided longer vacuum hose to the
vacuum TEE and install the open end onto the
intake plenum.