Installation Manual

INSTALLATION INSTRUCTIONS
Continued
7. Disconnect the crank case vent hose from the
crank case vent tube.
8. Lift up and remove the air lter housing from the
vehicle
NOTE: K&N Engineering, Inc., recommends
that customers do not discard factory air
intake.
9. Remove the bolt shown that secures the air box
mount bracket to the inner fender.
10. Remove the bolt shown that secures the
radiator to the core support.
NOTE: This bolt will be reused in a later step.
11. Install the two provided mounting studs onto
the two heat shield brackets (070061) as shown.
12. Install the two heat shield bracket assemblies
onto the heat shield as shown.
13. Install the provided lter adapter onto the heat
shield as shown.
14. Cut the provided edge trim into three sections.
One section is to be 6” long, one section is to be 7”
long and the nal section is to be 22” long.
15. Install the edge trim onto the heat shield and
lid as shown.
16. Install the heat shield assembly into position
so the mounting studs are in the air box mounting
grommets.
17. Install the K&N
®
air lter onto the lter adapter
and secure with the provided hose clamp.
18. Install the provided rubber mounted stud onto
the heat shield bracket (083164) as shown.
19. Install the heat shield bracket assembly onto
the heat shield and radiator mount as shown.
Secure the bracket with the factory bolt from step
number 9 and the hardware provided.
20. Install the rubber mounted stud into the into the
air box mounting plate bolt location as shown.
21. Install the provided bracket (083163) onto the
rubber mounted stud using the provided hardware.
22. Install the K&N
®
lter lid and secure with the
provided hardware.
NOTE: Install the bolt into the bracket 1st.
23. Install the provided hump hose (08699) onto
the lter adapter and secure with the provided
hose clamp.
24. Install the provided silicone hose (08690) onto
the throttle body and secure with the provided
hose clamp.