Installation Manual

INSTALLATION INSTRUCTIONS
Continued
ROAD TESTING:
* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
intake system’s air lter element every 100,000
miles. When used in dusty or off-road environ-
ments, our lters will require cleaning more
often. We recommend that you visually inspect
your lter once every 25,000 miles to determine
if the screen is still visible. When the screen is no
longer visible some place on the lter element, it is
time to clean it. To clean and re-oil, purchase our
lter Recharger
®
service kit, part number 99-5050
or 99-5000 and follow the easy instructions.
19600D
9/17/13
25. Install the 90º, ½” vent tting into the K&N
®
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
26. Install the provided crank case vent hose onto
the tting as shown
27. Remove the inlet air temperature sensor from
the factory intake plenum as shown.
NOTE: Use caution working with the inlet air
temperature sensor as it is very fragile.
28. Install the inlet air temperature sensor into the
K&N
®
intake tube as shown.
NOTE: Align the tab on the sensor with the line
on the sensor mount then rotate clockwise to
lock into position.
29. Install the two provided mounting head tie
wraps into the two provided brackets (070066) as
shown. NOTE: The tie wraps are to be installed
into the round holes.
30. Install the tie wrap equipped brackets onto the
factory intake tube mounting locations on the fan
shroud using the provided hardware. Then secure
the coolant over ow hose with the tie wraps.
31. Install the K&N
®
intake tube into the silicone
hose at the lter adapter and then into the hose
at the throttle body, then secure with the provided
hose clamps.
32. Connect the open end of the crank case vent
hose to the factory crank case vent tube as shown.
33. Reconnect the inlet air temperature sensor
electrical connection and then reinstall the engine
cover.
34. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
35. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections. Failure
to follow the above instructions or proper mainte-
nance may void warranty.