Installation Manual

This filter fits: SEE CATALOG FOR CURRENT APPLICATIONS
Congratulations, you have purchased the finest air filter that money can buy. With proper care, this filter will last
1 million miles or more. This filter can be used in a stock machine, with no modifications required. If any engine
modifications have been made tuning/jetting adjustments may be required. There are special installation
instructions, so please follow the procedures outlined below to ensure the K&N Filtercharger
®
seals properly.
INSTALLATION INSTRUCTIONS
Part Number HA-1801
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: [e-mail] • WWW: http://www.knfilters.com
17702a
10/10/05
THESE INSTRUCTIONS MUST BE FOLLOWED EVERY TIME THE FILTER IS SERVICED,
OTHERWISE THE FILTER MAY NOT SEAL, AND DAMAGE TO THE ENGINE COULD
RESULT.
1. Remove the stock air filter according to the service manual.
2. Remove the stock o-ring from the air box base. (Fig. 1)
3. Install the K&N Filtercharger
®
making sure it is completely seated
.
Note: The part number on the K&N Filtercharger
®
will be facing up. (Fig. 2)
4. Reinstall the air box lid and reassemble the bike per the service manual.
INSTALLATION
Fig. 1
Fig. 2