Installation Manual

This filter fits: SEE CATALOG FOR CURRENT APPLICATIONS
Congratulations, you have purchased the finest air filter that money can buy. With proper care, this filter can
last many seasons. This filter can be used in a stock machine, with no modifications required. If any engine
modifications have been made tuning/jetting adjustments may be required. There are special installation
instructions, so please follow the procedures outlined below to ensure the K&N Filtercharger
®
seals properly.
INSTALLATION INSTRUCTIONS
Part Number HA-5000
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: [e-mail] • WWW: http://www.knfilters.com
18419b
6/1/06
THESE INSTRUCTIONS MUST BE FOLLOWED EVERY TIME THE FILTER IS
SERVICED, OTHERWISE THE FILTER MAY NOT SEAL, AND DAMAGE TO THE
ENGINE COULD RESULT.
1. Remove the stock air filter.
2. Clean the inside of the intake tube.
3. Install the provided hose clamp onto the intake tube.
4. Install the K&N Filtercharger
®
in the air box.
Note: The flange of the K&N Filtercharger
®
will go inside the intake tube.
5. Press the flange of the K&N Filtercharger
®
all of the way into the intake tube.
6. Tighten the hose clamp.
7. Replace the air box lid and fasten the clips.
INSTALLATION
Fig. 1
Fig. 2
Available to purchase separately
Precharger Wrap; HA-5000PK