User manual

6
Part B: Moter
Suppose that you have selected Moter Antenna in the Antenna Connection window.
1. LNB Type: Select the proper LNB type.
2. Motor Type: Select between DiSEqC1.2 and USALS. If you select DiSEqC1.2, the
following Local Longitude and Local Latitude items will turn grey.
3. Delete All: Press OK key to pop up the dialogue "Are you sure to clear set satellite
position of this tuner?". Press OK key at the Yes button to clear all the memories about
the position of the satellites that has connected to the current turner.
4. Motor Setting: Press OK key to the Motor Setting window.
Satellite: Press keys to select the satellite in circle. Or press OK key to pop up the drop-
down list, then select the desired satellite in the list and press OK key to confirm.
Transponder: The same operation as the above.
Position No., & Save: The range is from 0 to 63. "0" delegates the original position.
You can select the proper value when you has rotated the antenna.
Go to X: Press OK key to pop up the drop-down list, select the proper position
(reference or from 1to 63) to realize the selected position.
West <Save> East: Press key to turn west, while press key to turn east. Press OK key to
pop up the dialogue "Are you sure to change this satellite's position?". Press OK key at the
Yes button to save the current position, or press OK key at the No button to cancel the
operation.
Recalculation: Press OK key to pop up the dialogue "Are you sure to change this
satellite's position?". Press OK key at the Yes button to recalculation.
5. Limit Setup: Press OK key to pop up the Limit Setup window.
Limit Setup: Press keys to switch among Disable Limit, East Limit and West Limit.
Limit Setup: Move cursor to the Limit Setup button. You can press key to turn west, or
press key to turn east.
Go to Reference: Press OK key to go to reference. If you select Disable Limit in the
above Limit Setup item, this button will turn grey.
6. If select USALS, Delete All item will turn grey.
Local Longitude, Local Latitude: Press keys to switch between West and East, or press
keys to switch between North and South. Press OK key to enter into the editing mode. Use
numeric keys (0-9) to input the longitude or latitude, press MENU key or EXIT key to exit.
The range of the longitude is from 0 to 180, while the range of the latitude is from 0 to 90. If
the inputted value is not in this range, system will pop up a dialogue "Our of Range" when
exit from this window. You can press OK key to close this dialogue.
7. Motor Setting: Press OK key to enter into the Motor setting window.
Satellite, Transponder: Press keys to select satellite or transponder, or press OK key to
pop up the drop-down list and select in the list.
English Deutsch Français Nederlands
Italiano Español Magyar Suomi Svenska Česky