LIBRETTO ISTRUZIONI E GB Manual de instrucciones Instruction book IG 656.
Contents Safety instructions 41 Disposal 41 Economical and ecological dishwashing 41 Installation instructions Building-in Levelling Fixing to adjacent units Water supply connections Water inlet hose with safety valve Water outlet hose connection Electrical connection 42 42 42 42 42 42 43 43 Description of the appliance 44 The control panel 44 Prior to using for the first time Setting the water softener Filling with salt Rinse aid 46 46 47 47 In daily use Loading cutlery and dishes The lower b
Safety instructions It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety.
Installation instructions Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Do not use, for connection, old hoses which have been used in another appliance. The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. Remove all packaging before positioning the machine.
Water outlet hose connection Electrical connection The end of the drain hose can be connected in the following ways: Information concerning the electrical connection is given on the rating plate on the edge of the dishwasher’s door. 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. Before plugging the appliance into the wall socket, make sure that: 1.
Description of the appliance 1. Upper basket stop 2. Water hardness switch 3. Salt container 4. Detergent dispenser 5. Control panel 6. Rating plate 7. Rinse aid dispenser 8. Filters 9. Lower spray arm 10. Upper spray arm 11. Upper basket 12. Worktop The control panel Function push buttons: in addition to the dishwashing Function push button 3 in 1: This appliance is equipped with the option 3 in 1, that allows the use of the "3 in 1" combi detergent tablets.
Indicator lights: have the following meanings: salt refilling indicator light, illuminates when the salt has run out rinse aid refilling indicator light, illuminates when the rinse aid has run out The salt and rinse aid indicator lights are never illuminated while a washing programme is running even if filling with salt and rinse aid is necessary.
Prior to using for the first time Before using your dishwasher for the first time: b) Setting electronically 1. Ensure that the electrical and water connections comply with the installation instructions (The dishwasher must be switched off) 2. Remove all packaging from inside the appliance The dishwasher is factory set at level 5. 3. Set the water softener 1. Press the On/Off push button. The On/Off indicator light illuminates. 4.
Filling with salt Rinse aid Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion.
● If you are using dishwasher detergent that already contains rinse aid, it is necessary to deactivate the inflow of rinse aid, in order to avoid a double dosage. Deactivation/activation of the inflow of rinse aid (The dishwasher must be switched off) When the inflow of rinse aid has been deactivated, also the rinse aid indicator light on the control panel is automatically deactivated. 1. Press the On/Off push button. The On/Off indicator light illuminates.
In daily use ● Check if it’s necessary to refill with special salt or rinse aid Loading cutlery and dishes ● Load cutlery and dishes into the dishwasher. ● Fill with dishwasher detergent . Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. ● Select a wash programme suitable for the cutlery and dishes. ● Start the wash programme. ● Before loading the dishes, you should: - Remove large left-overs.
The cutlery basket The upper basket Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the cup racks so that water can reach all surfaces.
Adjusting the height of the upper basket Use of detergent If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Only use detergents specifically designed for use in dishwashers. Using no more then the correct amount of detergent contributes to reducing pollution.
Different kinds of detergent Detergent tablets Use of "3 in 1" combi detergents Detergent tablets of different brands dissolve at different speeds. For this reason some detergent tablets cannot dissolve and develop their full cleaning power during short programmes. Therefore please use long programmes when using detergent tablets, to ensure the complete removal of detergent residuals. Do not place the tablets in the tub or in the cutlery basket as this will result in poorer wash results.
Washing programmes Programme Intensive 70° Auto 65° (1) Quick 65° (2) Eco 50° Rinse and Hold Degree of soil and type of load Programme push button Heavy soil. Crockery, cutlery, pots and pans Normal soil. Crockery and cutlery Fresh soil. Crockery and cutlery Normal soil. Crockery and cutlery Any. Partial load (to avoid food scraps from sticking together).
Starting a washing programme 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 7. End of the washing programme The dishwasher will automatically stop. The end of programme indicator light is illuminated. In the digital display appears 0 (remaining programme time), only in this case switch off the dishwasher.
Maintenance and cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). 9. Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment.
What to do, when... Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. ...a flashing fault code appears The dishwasher does not start or stops during operation. All push buttons are inoperative except for the On/Off push button. The indicator light of the programme in progress is flashing and a fault code visible in the digital display (see following chart).
...the wash results are not satisfactory The dishes are not clean ● ● ● ● ● ● ● ● The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. The spray arms do not rotate freely due to wrong arrangement of the load. The filters in the base of the washing compartment are dirty or incorrectly positioned. Too little or no detergent has been used.
Hints for test centres Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Washing programmes" chart). Test in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see "Washing programmes" chart).
Küppersbusch Hausgeräte AG Postfach 10 01 32, 45801 Gelsenkirchen, Hausanschruft: Küppersbuschstraße 16, 45883 Gelsenkirchen Telefon: (02 09) 4 01-0, Teletex: 20 931 810, Telefax: (02 09) 4 01-3 03 152967 21/1 Con riserva di modifiche - Salvo modificaciones Subject to change without notice 04/05
