User manual

14
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the On/Off push button
The display will show the last selected programme
(if with the last programme options have been
selected the corresponding indicator lights will
illuminate).
3. Check that there is rinse aid and salt
The corresponding indicator lights will illuminate
if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser.
Close the detergent dispenser lid.
Important!
If the half load option is selected remember to
reduce the quantity of detergent.
7a. Setting and starting the programme
without "delay start"
The selection of the programme occurs with the
door partially opened.
Press the "programme selector" push button until
the required programme number appears in the
digital display.
To see the duration of the programme (in minutes),
only with open door, press the "cancel" push
button
The following options may also be selected:
a- Half load: by pressing the corresponding
push button
b- Eco drying/no drying by pressing the
corresponding push button.
Close the door, the programme will start
automatically and an audible signal advises you of
this. All the indicator lights will turn off.
The display will show the running time of the
programme.
7b. Setting and starting the programme
with "delay start"
Once a programme and required options have
been selected (see point 7a.) to use DELAY
proceed as follows:
Press the DELAY push button. The digital display
will show "h 0".
If other options have been selected the
corresponding indicator lights will turn off, but this
will not modify the settings made previously.
Press the button again to select the number of
hours by which you wish to delay the programme
start (up to a maximum of 12 hours).
To set the time setting to zero press the DELAY
push button until "h 0" appears in the digital
display.
Close the door, an audible signal will confirm the
starting of the countdown.
The digital display shows the delay time, which will
decrease with steps of 1 hour.
Once the delayed time has elapsed the programme
will start automatically.
The opening of the door will not stop the
countdown.
8. To cancel a programme in progress
Open the door and press the "cancel" push button.
A audible signal informs you that the programme
under way has been cancelled, 3 horizontal lines
will appear in the digital display (for about 2
seconds), then the number of the last selected
programme will appear.
The dishwasher has now returned to setting mode
and it is now possible to select a new washing
programme.
To stop a countdown in progress, open the door
and press the "cancel" push button, in the digital
display appears the number corresponding to the
selected programme. The countdown has been
cancelled but the setting of the programme with
eventual options remains memorised.
Operating sequence