User manual

ManualsBrandsKüppersbusch ManualsDomestic AppliancesIK253-5Z-2T

MAINTENANCE

Unplug the appliance before carrying out

any maintenance operation.

Warning

This appliance contains hydrocarbons in its cooling

unit; maintenance and recharging must therefore

only be carried out by authorized technicians.

Interior light

The light bulb inside the refrigerator compartment

can be reached as shown in the figure.

If the light does not come on when the

door is open, check that it is screwed into place

properly. If it still does not light up, change the

bulb. The rating is shown on the light bulb cover.

Periodic cleaning

Clean the inside with warm water and bicarbonate of

soda. Rinse and dry thoroughly.

Clean the condenser (black grill) and the

compressor at the back of the appliance with a

brush or a vacuum cleaner. This operstion will

improve the performance of the appliance and save

electricity consumption.

Periods of non-operation

When the appliance is not in use for long periods,

take the following precautions:

remove the plug from the wall socket;

remove all food;

defrost and clean the interior and all accessories;

leave the door ajar to allow air to circulate to prevent

unpleasant smells.

Defrosting

Frost is automatically eliminated from the evaporator

of the refrigerator compartment every time the motor

compressor stops, during normal use. The defrost

water drains out through a trough into a special

container at the back of the appliance, over the

motor compressor, where it evaporates.

D411

D037

10 -1210 -1210 -1210 -123-63-63-63-63-41-2

Freezing Calendar

The symbols show different types of frozen goods.

The numbers indicate storage times in months for

the appropriate types of frozen goods. Whether the

upper or lower value of the indicated storage time is

valid depends on the quality of the foods and pre-

treating before freezing.

Open the door and push the appliance against the

side of the kitchen unit opposite to that of appliance

hinges.

Fasten the appliance with 4 screws provided in the

kit included with the appliance. Snap vent grille (C)

and hinge cover (D) into position.

D724

Apply the sealing strip pushing it between the

refrigerator and the adjacent cabinet.

It is necessary that the niche is provided with a

conduct of ventilation having the following

dimensions:

Depth 50 mm

Width 540 mm

Slide the appliance into the recess, pushing it

against the wall on the handle side.

PR01

540

D015

D728