User manual

5 cm
min.
200 cm
2
min.
200 cm
2
Door reversibility
WARNING! Before carrying out
any operations, remove the plug
from the power socket.
CAUTION! To carry out the
following operations, we
suggest that this be made with
another person that will keep a
firm hold on the doors of the
appliance during the operations.
1. Loosen and remove the upper pin.
2. Remove the door.
3. Remove the spacer.
4. With a key, loosen the lower pin.
5. Tighten the lower pin on the opposite
site.
6. Install the spacer.
7. Install the door.
8. Tighten the upper pin.
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal adheres to
the cabinet.
• The door opens and closes
correctly.
If the ambient temperature is
cold (i.e. in Winter), the gasket
may not fit perfectly to the
cabinet. In that case, wait for the
natural fitting of the gasket. In
case you do not want to carry
out the above mentioned
operations, contact the nearest
After Sales Service Force. The
After Sales Service specialist will
carry out the reversibility of the
doors at your cost.
Installing the appliance
CAUTION! Make sure that the
mains cable can move freely.
1. If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
25