User manual

11
O Alarm reset light
P Alarm reset button
In the event of an abnormal temperature rise inside
the freezer (e.g. power cut) warning light (O) will
start to flash and a buzzer will sound.
After the temperature has returned to normal, the
warning light (O) will continue to flash, although the
buzzer has stopped.
When the alarm button (P) is pressed, the warmest
temperature reached in the compartment flashes on
the indicator (K).
If the power has been off for a long time, frozen food
should be consumed as quickly as possible, or
cooked and then re-frozen.
Operation
Insert the plug in the power socket. Press the button
ON/OFF (B). The freezer is switched on.
The freezer is pre-set to run at -18°C. this
temperature will be reached in a few hours.
As soon as the appliance is switched on the
temperature indicator (D) shows the current
temperature inside the freezer, the alarm reset light
(H) flashes and a buzzer sounds. Press the alarm
reset button (I). The buzzer stops and the alarm light
(H) continues to flash until the setting temperature is
reached.
Freezing fresh food
To freeze fresh food, press the Super Frost button
(G).
Place the food to be frozen in the upper
compartment. The maximum quantity of food which
can be frozen in 24 hrs. is shown on the rating plate;
Warning!
When use the “Super Frost” function:
about 6 hrs
before
about 24 hrs
before
not needed
not needed
Introducing small quantities of fresh food
(about 5 kg)
Introducing the maximum quantity of food
(see rating plate)
Introducing frozen food
Introducing small quantities of fresh food
daily 2 kg maximum
Freezing fresh food
The 4-star compartment is suitable for long term
storage of commercially frozen food and for freezing
fresh food.
To freeze fresh foods allow it to run on the fast
freeze setting for at least 24 hours before loading
food.
Place the food to be frozen in the compartments as
shown in figure.
10 kg
10 kg
Storage of frozen food
When first starting-up or after a period out of use,
before putting the products in the compartment let
the appliance run for at least two hours on the fast
freeze setting, then turn the thermostat knob to the
normal operating position.
Important
If there is a power failure when food is in the
freezer, do not open the door of the freezer
compartment. The frozen food will not be
affected if the power cut is of short duration (up
to 6-8 hours) and the freezer compartment is full,
otherwise, it is recommended that the food
should be used within a short time (a
temperature increase of the frozen food shortens
its safe storage period).
Thawing
Deep-frozen or frozen food, prior to being used, can
be thawed in the refrigerator compartment or at
room temperature, depending on the time available
for this operation.
Small pieces may even be cooked still frozen, directly
from the freezer: in this case, cooking will take longer.
Ice-cube production
This appliance is equipped with one or more trays
for the production of ice-cubes. Fill these trays with
water, then put them in the freezer compartment.
Do not use metallic instruments to remove the
trays from the freezer.
14
PR01
540
50
B
T
H
50 mm
min.
200 cm
2
200 cm
2
min.
D567
Dimensions of housing
Height 1780 mm
Depth 550 mm
Width 560 mm
For safety reasons, minimum ventilation must be as
shown in Fig.
Attention: keep ventilation openings clear of
obstruction.
It is necessary that the niche is provided with a
conduct of ventilation having the following
dimensions:
Depth 50 mm
Width 540 mm
For installation see the instructions enclosed.
ATTENTION!
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.