HDS Super HDS 695 S HDS 745 HDS 895 S HDS 995 HDS 1195 HDS 1295 www.karcher.com 5.
HD S Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 1 5 2 6 3 7 4 8 2
HD S Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 9 13 10 14 11 15 12 16 3
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 4 CONTENTS Environmental protection 4 Faults 11 Illustration of the unit 5 Warranty 13 Operating controls 5 General information 13 Note on the operating instructions Technical data 14 6 Spare Parts List 16 Commissioning Check the oil level Filling with scale inhibitor Filling with fuel Filling with cleaning agent Mounting handgun Mounting handle Water connection Drawing in water from tank Mains connection 6 6 6
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 ILLUSTRATION OF THE UNIT CONTROL ELEMENTS 1 Fuel tank inlet 2 Handle 3 Instrument panel 4 Window with the maintenance/fault display (only HDS 995, HDS 1295) 5 Cover latch 6 Compartment für accessories 7 Short operating instructions 8 Cover for compartment 9 Unit cover 10 Cover for tank inlet 11 Tank inlet für scale inhibitor 12 tank inlet for cleaning agent 13 High-pressure nozzle 14 Handle grips in the chassis 15 Steel pipe 16 P
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 6 NOTE ON THE OPERATING INSTRUCTIONS All of the item numbers described below in the operating instructions are referenced in the illustration of the unit. COMMISSIONING – Unit, piping, high-pressure hose and connections must be in perfect working order! – Lock the hand brake.
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 Drawing in water from tank When you suction water out of an open container you should – disconnect the water inlet at the pump head. – unscrew the top supply hose to the water tank and connect it to the pump head. – use a water suction hose with a minimum diameter of 3/4" provided with a vacuum filter. * Until the pump sucks up water you should: – turn the pressure and flow regulation to MAX.
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 Measuring out the cleaning agent * Use cleaning agents sparingly to protect the environment * The cleaning agent must be suitable for the surface to be cleaned.
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 9 DISCONTINUATION OF USAGE Safety shut-off The pump automatically shuts down for safety reasons if the handgun is neither opened or closed for more than 30 minutes. – To switch it on again turn the main switch to "0" and then back to the "I" position. (The EPROM without disabling 6.682-595.
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 Once a month – Clean strainer in low water protection – Clean filter at cleaning-agent suction hose After 500 hours of operation, at least once a year – Change oil MAINTENANCE TASKS 10 Display Necessary maintenance work – Check the overflow valve for leaks * – Check the high-pressure hose * – Clean the handgun – Check the pulsation damper * * This maintenance work should be performed only by after-sales service.
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 – Tighten drain plug again – Slowly fill with oil as far as MAX mark Air bubbles must be able to escape Refer to technical data for oil grade and quantity to be used. FAULTS The indicator lamp- MOTOR/ELECTRONICS MODULE (item 28) flashes (only HDS 995 and HDS 1295) * This warning lamp flashes if there is a problem.
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 Unit does not run (HDS 745, HDS 695 S, HDS 895 S, HDS 995, HDS 1195, HDS 1295, HDS Super) No mains voltage – Check mains connection/power cord Unit does not build up pressure (HDS 745, HDS 695 S, HDS 895 S, HDS 995, HDS 1195, HDS 1295, HDS Super) Air in system – Bleed pump: * Set the cleaning agent metering valve (item 31) to "0" * While the handgun is open switch the unit on and off several times with the unit switch.
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 WARRANTY The warranty terms and conditions issued by our responsible sales company apply in every country. Within the warranty period, any faults in the unit will be rectified free of charge provided that the problem was caused by a material defect or manufacturing error.
Connected load Fuse (slow blow) Water connection Supply temperature Supply volume Suction height when drawn from open tank (at 20°C water temperature) Performance data Flow rate: cold/hot water Operating pressure: cold/hot water (with standard nozzle supplied) Flow rate: steam Operating pressure: steam (with steam nozzle (4.
Connected load Fuse (slow blow) Water connection Supply temperature Supply volume Suction height when drawn from open tank (at 20°C water temperature) Performance data Flow rate: cold/hot water Operating pressure: cold/hot water (with standard nozzle supplied) Flow rate: steam Operating pressure: steam (with steam nozzle HDS 995: 4.766-023 ; HDS 1195 and HDS 1295: 4.
HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 16
EU DECLARATION OF CONFORMITY We hereby declare that the equipment described below conforms to the relevant fundamental safety and health requirements of the appropriate EU Directives, both in its basic design and construction as well as in the version marketed by us. This declaration will cease to be valid if any modifications are made to the machine without our express approval. Product: High-pressure cleaner with steam stage Model: 1.025-xxx, 1.026-xxx, 1.027-xxx, 1.