User's Manual

EN | 15
EN
BATTERY REPLACEMENT
When batteries become weak, the operating distance of the Remote Controller is greatly reduced and
you will need to replace the batteries.
USING THE REMOTE CONTROLLER CORRECTLY
Point the remote controller at the REMOTE SENSOR located to the left bottom of the device.
When there is a strong ambient light source, the performance of the infrared REMOTE SENSOR may
be reduced, causing unreliable operation.
BASIC OPERATIONS (FOR CD/MP3)
1. Switch the unit on by pressing the POWER switch.
2. Set the MODE SELECTOR knob to “CD.USB.SD”, the CD indicator on the CD control panel will
be lit up (“OP”).
3. Flip open the semi circular transparent door.
4. Turn the “RESET POINTER” to the “OFF” position and place a disc onto the disc tray (make sure
the “RESET POINTER” is in the “ON” position after the disc has been loaded).
5. Press ►►| (NEXT) to skip ahead to next track.
6. Press |◄◄ (BACK) to skip back to previous track.
7. Press ►► to fast forward the current track. Press ►|| PLAY/PAUSE to resume normal playback.
8. Press ◄◄ to fast rewind the current track. Press ►|| PLAY/PAUSE to resume normal playback.
9. Press F+10 to skip 10 songs forward. This is helpful when you have a disc with many songs on it.
10. Press F-10 to skip 10 songs back. This is helpful when you have a disc with many songs on it.
11. Press ►|| PLAY/PAUSE button to play disc, press twice to temporarily stop disc play at the cur-
rent play position, Press the button again to resume disc play from the pause mode.
12. Press ■ STOP button to stop playing disc.
13. To take out a disc, rst set the RESET POINTER back to “OFF”.
Notes:
• If the disc is seriously scratched or too dirty, disc play may not start.
• If an improperly centered disc is played, noise can be heard in the mechanism. The use of such
discs should be avoided.
• Do not tilt the unit with discs loaded. Doing so may cause malfunctions.
• During the electrostatic discharge, the product may be malfunctioning. Reset it to return its nor-
mal operation.
REPEAT MODE “REP” (FOR CD/MP3)
Mode sequence REPEAT > REPEAT ALBUM (FOR MP3 ONLY) > REPEAT ALL > CLEAR
1. Press REP button once. The current track will be repeated.
2. Press REP button again. The disc will play through each track in a single folder to the end (FOR
MP3 PLAYBACK ONLY).
3. Press REP button again. The complete disc will be repeated.
4. Press REP button again to resume normal playback.
Notes on CD-R/RW discs:
• Because of non-standardized format denition/ production of CD-R/RW, playback quality and
performance are not guaranteed.
• Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions, such
as PC performance, writing software, media ability, etc.
• Do not attach a seal or label to either side of the CD-R/RW disc. It may cause a malfunction.
RANDOM MODE (FOR CD/MP3)
To play all tracks on a disc in a random order, press the RANDOM button. “RANDOM” will be shown in
the display.
To resume normal playback, press the RANDOM button again.