Owner's Manual

10 11
Quiet Ride
The Quiet Ride function will automatically silence all radar and laser
alerts when traveling under a speed selection of your choice be-
tween 5-75 mph in 5 mph increments, or 10-120 kph in 10 kph
increments.
Visual alerts are unaffected by Quiet Ride settings.
The factory default setting for Quiet Ride is “20 mph”.
Activating/Adjusting Quiet Ride
• Press and release button on remote control to activate
the Quiet Ride menu. Voice will announce the current setting, e.g.
“Quiet Ride 20”, or the current speed setting.
• Press and release or buttons to adjust the speed
settings on Quiet Ride. Any selected speed setting indicates Quiet
Ride is on.
• When you have made your desired Quiet Ride speed selection, stop
scrolling and voice will announce, “Quiet Ride Set”.
NOTE: Locations that you have “Marked to Alert” (page 12) are
unaffected by Quiet Ride settings.
Mute Functions
Your K40 system provides two options to mute audio alerts (both
voice and tones):
• Press and release button to mute audio for 30 seconds or
the duration of the alert. Voice will announce, “Mute On”.
• Press and hold button for three seconds to mute audio for
5 minutes. Voice will announce “Extended Mute On”. Press and
hold MUTE button for three seconds to turn Extended Mute off.
• To turn the voice and tone alerts off, press and release button
until voice announces, “Volume Off”. You will continue to receive
visual alerts.
MUTE
MUTE
-
Mark to Mute
The Mark to Mute function allows you to mute any stationary radar
band/laser alert from a non-police source (e.g. an automatic door) in a
specific GPS location.
Using Mark to Mute
• Press and release button to mute a specific radar band/laser
alert. A signal must be present in order to mark a location for mute.
• A voice announces that a specific radar band/laser alert has been
muted (e.g. “K Muted”).
• You will no longer receive audible alerts for the muted radar band/laser
alert when within a 1,500 ft. radius of the muted location.
• You can string multiple muted locations together to extend the
1,500 ft. radius.
• You will still receive visual alerts from the alert LED(s).
• All other radar bands/laser alerts remain unaffected.
To remove a previously muted radar band/laser alert from
your database:
• Press and release button while in the marked location.
• Voice announces that a specific radar band/laser alert has been
removed (e.g. “K Muted Removed”).
To remove ALL stored muted radar bands/laser alerts:
• Press and hold button for ten seconds at any time.
• Voice announces, “All Muted Locations Cleared”.
MM
MM
QUIET
RIDE
+
-
MM
*PLATINUM 360_200 OWNERS .qxp_Layout 1 3/23/20 3:13 PM Page 8