Wiring Guide

HOST
(HOSTdi)
IGNITION
SWITCHED
+12 VOLTS
RED
WHITE
GRAY
GRAY
WHITE
BLUE
FRONT
RADAR
LED/POD
REAR
RADAR
LED/POD
GRAY
CONNECTS
TO DEFUSER
INTERFACE
MODULE
*NOTE: DRILL 3/16” HOLE FOR LED.
BLUE
GROUND
#8 X 1/2"
TEK SCREW
BROWN
REAR RADAR
RECEIVER
(RLR)
FRONT RADAR
RECEIVER
(RLF)
GPS
MODULE
(GPSi)
BLACK
PURPLE
ORANGE
BLACK
GREEN
BROWN
BLUE
SPEAKER
3 AMP FUSE
BROWN
WHITE
GREEN
REMOTE
CONTROL
(RCUi)
USE THE SUPPLIED 2-WAY TAPE TO
MOUNT TO DASH,FRONT WINDSHIELD
OR REAR WINDSHIELD DECK.
RECEIVERS MUST BE
INSTALLED HORIZONTALLY.
DO NOT OBSTRUCT UNIT
FACE WITH METAL, CHROME-
PLATED PLASTIC OR
CARBON FIBER.
RECEIVERS MUST BE
INSTALLED HORIZONTALLY.
DO NOT OBSTRUCT UNIT
FACE WITH METAL, CHROME-
PLATED PLASTIC OR
CARBON FIBER.
DEFUSER
INTERFACE
MODULE
H
O
S
T
L1
L2
L3
L4
L5
( FOR OPTIONAL DEFUSER(S) )
(
DO NOT TAP INTO FACTORY GROUND WIRE)
(INTERIOR
MOUNTING
ONLY)
(RL360di MODEL ONLY)
YELLOW
YELLOW
OPTIX 1-5 TRANSPONDERS
g5 1-4 TRANSPONDERS
(INTERIOR
MOUNTING
ONLY)
MUTE IN
GREEN
BROWN
BLUE
YELLOW
BROWN
WHITE
GREEN
YELLOW
WHITE
BLACK
MUTE OUT
I/O PORTS
ORANGE
BLOCK WIRING DIAGRAM
RL360di
RL200di
K40 DAYTIME TECHNICAL SUPPORT
800-323-6768
24 HR. TECHNICAL SUPPORT
800-784-9144
44875 1/18
IGNITION AND GROUND
1. Use a test meter to locate a +12v
ignition switch source for the
Host.
2. Connect the black wire to a solid
chassis ground (K40 recommends
the driver’s side kick panel) using
the provided ring terminal and
silver self-tapping screw.
When Orange wire is connected
t
o low beam headlight power
and headlights are turned on,
alert LEDs will auto dim into
“night” mode.