User's Manual

Each receptacle is limited to 333W
A14G0846
533299
2008
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception. Which can be
determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
--Consult the dealer or an experienced radio/TV technician for help.
INSTALLATION:
1. Mount or hang the RECEIVER on the wall near a wall grounded electrical
120V 60Hz outlet which the power supply cord of the RECEIVER will plug
in to.
2. Plug the cord of the device you wish to control remotely at the bottom
of the RECEIVER.
3. The heat dissipation hole of the bottom must be stuck on the wall closely.
4. The device must be mounted in an attitude that the heat dissipation
openings at the bottom enclosure shall be stuck on the wall closely and
in a vertical position with the receptacle facing downward and with the
receptacles at least 2 feet (610 mm) above the ground level not for water
immersion.
Operation:
• Function A - Fading: 3 outlets turn light fading rotational by each outlet
(turn off by function E)
• Function B - Chasing: 3 outlets turn light ON/OFF rotational by every 2
outlets (turn off by function E)
• Function C - Flashing: 3 outlets turn light
ON/OFF by sec for flashing
Event (turn off by function E)
• Function D - Dancing: Cyclic repeat function
A to C (turn off by function E)
• Function E - Switch: Turn 3 outlets power
ON/OFF as regular remote
Chasing
Dancing
Fading
On/Off
Flashing
IMPORTANT INFORMATION REQUIRED BY THE FCC
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.