User's Manual

Battery Replacement
Remove the Battery compartment cover from
the back of the remote control by sliding the
cover in the direction that its trends curve.
Remove the spent battery and place a new
DC 12V Type A23 battery into the Battery
Compartment correctly observing the polarity
indications (+/-) inside the Battery
Compartment.
Replace the Battery Compartment Cover.
•
•
•
Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
•Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help."
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation of the device.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
Made in China