Installation Instructions

ON OFF
2Hr 4Hr
6Hr 8Hr
Timer
1. Press the timer control button (3) to turn on all outlets On-Always
On. The power indicator (2) will be lit.
2. Press the timer control button (3) to Sensor ( dusk-to-dawn).
The indicator (2) will be lit and all outlets will be ON when sensing
dusk and Off at dawn.
3. Press the timer control button (3) to Sensor plus 2hr, 4hr, 6hr or
8hr. The indicators (2) for the Sensor and specific hour you
selected will be lit. All outlets will turn on when sensing dusk and
then off after hour your selected.
4. Press the timer control button (3) to Timer 8hr, 6hr, 4hr or 2hr. The
indicators (2) for the Timer and specific hour you selected will be
lit. All outlets turn on immediately then off after the hour you
selected. The current setting will repeat daily.
1. Press the ON or OFF button to turn the receiver power ON or
OFF.
2. Press Timer button plus 2Hr, 4Hr, 6Hr or 8Hr to turn on the
receiver on then off after that specific hour you selected. The
power will be repeated ON daily.
3. Press Sensor button ( dusk-to-dawn), the receiver will be ON
when sensing dusk and Off at dawn.
4. Press Sensor button plus 2Hr, 4Hr, 6Hr or 8Hr to turn on the
receiver after sensing dusk then off after specific hour you
selected.
Battery Handling and Usage
• Install the battery observing the positive (+) side up as indicated
inside the battery compartment.
• Never throw batteries into a fire. Do not expose batteries to fire or
other heat sources.
• Battery contains mercury. Do not put in trash. Recycle or manage
as hazardous waste.
• Remove the battery compartment cover away from the remote (see
diagram below)
• Remove the old battery and place a new Type 3V (CR2032) lithium
battery into the battery compartment.
• Ensure the battery is installed correctly with the
positive (+) side up.
+
CR2032
3V
• Replace the battery compartment cover.
• Dispose or recycle spent/discharged batteries in compliance with
all applicable laws. For detailed information, contact your local
solid waste authority.
Caution: Failure to properly align the battery polarity can cause
personal injury and/or property damage.
1
Frequency: 433MHz
Transmitter Power Input: 3V Lithium Battery (CR2032)
Receiver Power input: AC 125V Electrical Outlet
Receiver Power Output: 13 Amps / 125 Volts / 1625W
Cord: 6ft SJTW 16/3C
RECEIVER MODEL: SP-058A
TRANSMITTER MODEL: TR-034-8
FCC ID: PAGTR-034-8
WARNING:
Do not ingest the battery, Chemical Burn Hazard (The remote control
supplied with) This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death. Keep new and used
batteries away from children. If the battery compartment does not
close securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any
part of the body, seek immediate medical attention.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate this equipment.
CAUTION:
• Risk of Fire. Not for permanent installation. Use only with outdoor
equipment, Christmas-tree, or other seasonal decorative-lighting
products having a total of 13 Ampere maximum. Do not install or
use this product for more than a 90-day period.
• If using Christmas tree or decorative-lighting products that are not
marked with an ampere rating, connect no more than 140 screw-
base lamps (C7 or C9) or 12 strings with midget (push-in) lamps to
this cord set.
• Cord sets must be plugged into a GFCI-protected receptacle.
• If using an outdoor-use cord set for an extended period of time
(greater than 90 days) please consider hard wiring a permanent
outdoor-use receptacle rated for year-round use in the area that
power is needed. Please contact a licensed electrician for proper
installation of permanent wiring.
• After completion of installation, the connector shall be maintained a
minimum of 6 in. above ground.
• SUITABLE FOR INDOOR/UTDOOR USE – STORE INDOORS
WHILE NOT IN USE.
WARNING: Disregarding Cautions may cause damage, fire, or fatal
shock. When using outdoor electrical products, basic safety
precautions should always be followed to reduce the risk of fire,
electric shock, and personal injury.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits
for Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
+
CR2032
3V
ON OFF
2Hr 4Hr
6Hr 8Hr
Timer