Use and Care Manual

ASSEMBLY INSTRUCTIONS:
PARTS LIST
NO TOOLS
REQUIRED FOR
ASSEMBLY
1
Screw PART B into PART A in a clockwise direction until it stops. Do not
overtighten. Screw PART C into PART B in a clockwise direction until it stops.
Do not overtighten. See step 2 for length adjustments.
IMPORTANT SAFETY INSTRUCTIONS:
• Always maintain a safe distance from the re when operating the Blow Stick
™
.
• When operating the Blow Stick
™
, make sure not to breathe in when engaged with
the mouthpiece, as dangerous debris/ soot could be inhaled. ONLY exhale through
the Blow Stick
™
and inhale away from the re before using again.
• If The Blow Stick
™
does become obstructed, disassemble each part and clear the
debris before resuming use.
• The head at the end of the Blow Stick
™
will become hot. Do not touch the head
and or lower shaft for any reason after recent use as it can cause serious burns.
• After use, the Blow Stick
™
will be hot and may have some debris/ soot on it. Be
careful when placing it down, as it could damage/ stain other materials that it comes
in contact with.
• Do not leave the Blow Stick
™
in the re for an extended period of time as it will
damage the parts. After use, immediately place the Blow Stick
™
off to the side in a
safe location.
• The Blow Stick
™
is for adult use only and is not safe for children.
CARE INSTRUCTIONS:
• The Blow Stick
™
is made of durable coated steel and natural hardwood in order to
withstand the elements. If wear on the wooden handle becomes apparent, applying
a new coating of natural oil may be necessary to prolong the life of the material.
• Periodically check that the components are screwed tightly together to ensure all
parts are secure and in proper working order.
• When not in use, the Blow Stick
™
should be stored indoors.
Visit us at kabintool.com for more information or to contact us at any time. Thank you!
1 YEAR LIMITED WARRANTY - This product is guaranteed to be free from defects in
material and workmanship for one (1) year following the date of purchase. Please
visit www.kabintool.com/warranty for full warranty details and limitations and to
register your product for warranty.
(PART A)
(PART B)
(PART C)
2
The Blow Stick
™
can be assembled in
two lengths, 33” and 49”, depending on
desired use. For the full length, assemble
parts A, B and C. For the shorter length,
do not use PART B and screw PART
C directly into PART A in a clockwise
direction. Do not overtighten.
33"
49"
3
The rubber end cap can be
removed and easily cleaned,
simply pull to remove it and press
back into place for use.
(PART A)
(PART B)
(PART C)
(PART A)
(PART C)
PART A (x1)
PART B (x1)
PART C (x1)
PART D (x1)