Instructions / Assembly

ASSEMBLY INSTRUCTIONS

NOTE: Tool Required for Assembly: phillips screw driver ( NOT included)

NOTE: DO NOT tighten the screws completely.

1. Carefully unpack all parts from the box, compare parts with package content listed above, make sure all

parts are present before beginning assembly of product. If any part is missing or damaged, do not attempt

to assemble the product. Contact customer service for replacement parts.

2. Attach the Left Panel (C) to Front-Left Leg (H) and Back-Left leg (I) with Bolt (AA) and Washer (BB) by using

the Hex Screw Driver (CC). Attach the Back Panel (E) to Back-Right Leg (G) and Back-Left leg (I) with Bolt

(AA) and Washer (BB) using the Hex Screw Driver (CC), (see Figure 2).

3. Attach the Right Panel (B) to Front-Right Leg (F) and Back-Right leg (G) with Bolt (AA) and Washer (BB) using

the Hex Screw Driver (CC), (see Figure 3).

4. Attach the Upper Beam (J) to the Front-Left Leg (H) and the Front-Right leg (F) with Bolt (AA) and Washer

(BB) using the Hex Screw Driver (CC). Attach the Bottom Beam (K) to the Front-Left Leg (H) and the

Front-Right leg (F) with Bolt (AA) and Washer (BB) using the Hex Screw Driver (CC), (see Figure 4).

NOTE: DO NOT tighten the screws completely.

Hardware Used:

AA Bolt (M6 x 15) x 4

BB Washer (M6) x 4

CC Hex screw driver x 1

Hardware Used:

AA Bolt (M6 x 15) x 8

BB Washer (M6) x 8

CC Hex screw driver x 1

Figure 2

Figure 3