Instructions / Assembly

8. Attach the assembled base to the Table Top Assembly (A) with Bolt (AA) and Washer (BB) using the Hex Screw

Driver (CC). Make sure the control panel just covers up the notch on the Right Panel (B), (see Figure8). Then

tighten all the screws completely.

Put the Lava Rock (P) around the burner, then remove the label from the pilot box (see Figure 9). A gas fire pit

requires 13.2 lbs lava rock. NOTE: DO NOT completely cover the burner element or block the pilot box

with the lava rocks. When the first use, preheat the lava rocks for 15 minutes to burn out the impurities

and air in the natural lava rocks.

NOTE: DO NOT tighten the screws completely.

WARNING: keep children away during assembly, as this item contains lava rock, which are small pieces and

can be swallowed by children.

Hardware Used:

AA Bolt (M6 x 15) x 4

BB Washer (M6) x 4

CC Hex screw driver x 1

7. Un-screw the Handle Assembly (O), attach the Handle to the Door (D) using the phillips screw driver, then

screw it tightly (see Figure 7).

NOTE: DO NOT tighten the screws completely.

Figure 7

Figure 8

Figure 9

pilot box

FOR YOUR SAFETY: Surfaces of fire pit can remain extremely hot for

a period after use. Allow 45 minutes to cool down before touching or

moving the fire pit.