Use and Care Manual
Table Of Contents
- 6. Display function
- TIME：0:00 – 99.59(MIN)
- DISTANCE: 0.00 – 99.0(MILE)
- CALORIES: 0.0 – 990 (KC)
- SPEED: 0.6 – 6.2(MILE/H)
- 10. (FAT) Body Fat Test
- 11. Others
- 11.3. Countdown time, countdown calorie and countdown distance can only be set up for one of them. The last time setting will be implemented. The parameter set will be counted backwards while other parameters will be counted forwards.
- 11.4. The standard calorie is 30kcal/km.
- 11.5. The acceleration is 0.5Km/S and the deceleration is 0.5Km/S.
11
We suggest that you should cut off the power for 10Mints after keep running 1.5hours to
maintain the treadmill.
The belt would slip if too loose during using；if the belt is too tight, it would affect the
performance of motor and increase the abrasion of roller and belt. The belt can be lift away
from the deck for around 50 — 75mm if the degree of tightness is just well.
Center the running belt
CONSOLE OPERATION GUIDE
一、 Place treadmill on a level surface. Run Treadmill at
approximately 6-8KM/H, checking the running
condition. If the belt has drifted to the right, pull out of
the save clock and switch, and turn the right adjusting
bolt 1/4 clockwise, then start running to see if centered
or not. Keep adjusting until centering the belt.
PICTURE - A
二、 If the belt has drifted to the left ,pull out of the safety
clock and switch, turn the left adjusting bolt 1/4 turn
clockwise, then start running to see if centered or not.
Keep adjusting until centering the belt. PICTURE - B
三、 Adjust the belt after a period of using time. Pull out of
the safety clock and switch , turn the left and right
adjusting bolt 1/4 clockwise, then re-start running to
check the belt-tightness until the belt is in right
tightness. PICTURE - C