Use and Care Manual

13
set up relevant countdown value. After the completion of the setting, press START can start
the treadmill.
5.4. Speed keys:
“SPEED+” and “SPEED -” are acceleration and deceleration keys: They may be used to
adjust parameter setting when setting up parameters of the treadmill. When the treadmill is
running, they are used to adjust the speed for 0.1mile/time; for long-time pressing for more
than 2s, automatic continuous acceleration and deceleration will be realized.
The two keys are on the handle.
6. Display function
6.1 Speed display
Display the current running speed.
6.2 Time display
Display the running time under manual mode or the countdown running time under mode and
programmed mode.
6.3. Distance display
Display the accumulated distance under manual and programmed mode or the countdown
distance under mode running state.
6.4. Calorie display
Display the accumulated calories under manual and programmed mode or the countdown
calories under mode running state.
6.5. Heart rate display
When heart rate signals are detected, the heart shaped icon flashes and the pulse value will
be displayed.
6.6. Data display range of various parameters:
TIME：0:00 – 99.59(MIN)
DISTANCE: 0.00 – 99.0(MILE)
CALORIES: 0.0 – 990 (KC)
SPEED: 0.6 – 6.2(MILE/H)
PULSE: 50 – 200 (BPM）
7. Heart rate measurement function
While the treadmill is connected to the power, hold the pulse tester for 5s and the heart rate
value will be displayed. The initial value is the actually measured heart rate, and its display
range is: 50-200 times/ minutes. In the heartbeat measurement process, there will be a heart
shaped icon flashing.
Heart rate displayed is for reference only and can’t be used as medical data.
8. Auto program
The default running time is 10 mins. Set the running time after choosing the program. Each
program is divided into 10 sections; the operation time will be evenly distributed to each
program section. Here below is a 10-section program running diagram.