User Manual

Page 16
4 Installation Procedures Under
Windows NT 4.0
Use the procedures described in this section to install and
configure the KAI-LINK Wireless LAN Card under MS Windows
NT 4.0.
4.1 Installing the Driver Under Windows NT 4.0
First of all, in order to obtain the necessary privileges for the
driver installation, you need to log on as Administrator to
Windows NT 4.0. Since Windows NT 4.0 do not support “Plug &
Play”, you must enable the detection of PC cards by the
operating system by following the following procedure:
1. Click Start->Settings->Control Panel
2. Double-click the “Devices” icon
3. Select “PCMCIA” from the list and click the “Startup” button
4. Set the Startup type to “Boot” and click “OK”
5. Click “Close” on the “Devices” window
In order to let the operating system know about your new card,
you must enable the Network support by following the next
steps:
1. Click Start->Settings->Control Panel
2. Double-click the “Network” icon
3. In the “Network Settings” window you will be prompted to
install Windows NT Networking in case no network has been
installed yet. Click “Yes” and follow the instruction on the
screen. If networking had been already installed, you will see
a dialog with several tabs. In the “Adapters” tab click the
“Add” button. Windows NT Networking Setup will determine
the type of network adapter card that you are going to use.