User Manual

Page 7
3 Installation Procedures Under
Windows/95/98/Me/2000
Use the procedures described in this section to install and
configure the KAI-LINK KWL-210/220 Wireless LAN Card under
MS Windows 95/98/Me/2000.
3.1 Installing the Application and Drivers Under
Windows 95/98/2000
Note: Please do not insert your PCMCIA card until the
Application setup has been completed. The setup
procedure described below installs both the drivers, the
Configuration & Monitor Utility, and the Firmware
Upgrade Utility.
1. Insert the Firmware and Software Tools CD your CD-ROM
drive and locate the executable file “setup.exe”.
2. Follow the installation instructions from the InstallShield
Wizard by pressing the “Next” button.
3. During the setup process, the window of Figure 3-1 will
going to install. If you have no plans to install an USB WLAN
adapter onto the specific computer, then select the
“Application & PCMCIA Drivers” option. On the other hand, if
you have already installed a USB adapter, cancel this setup
and after you have uninstalled the old USB driver and
application, re-run this setup and select the “Application,
PCMCIA & USB Drivers” option. Finally, if you have plans to
install an USB WLAN adapter in the future, select the
“Application, PCMCIA & USB Drivers” option.
Note: The window of Figure 3-1 will not appear during the
installation under Windows 95 since Windows 95 does
not support USB.