User's Manual

---------------------------------------------------------------------------------------
☆ Note
Please make sure to use the product accompanying power adapter(adapter spec are as follows positive with photo)
use other adapter may cause routers damage.
---------------------------------------------------------------------------------------
Chapter 2: Build your network
Router placement
For wireless best wireless signal transmission between the router and the network devices connected, before
deciding the location of your router, please confirm the following:
● try to place the router in a central area of buildings, in order to cover all the wireless devices
● recommended on the metal objects near or direct sunlight unsheltered
● try strong wave, engine, microwave, refrigerator, and other means to distance power with other Wi-Fi router,
the router in order to prevent signal interference or not receivedto signal
● Keep the router a good ventilationlocal
System requirement to use products:
before setting up your network, use your computer must meet the following system requirements:
● A RJ45 ether net port (LAN Port) 10Base-T / 100bASE-TX / 1000BaseTX)
● Support IEEE 802.11 a / b / g /Wi-functional
● System supports TCP / IP service
● Web browser can be used, such as Google chrome, Firefox, Safari, Opera, etc.
---------------------------------------------------------------------------------------
☆ Note
Please note sure your computer has a configuration of any network device.
When the network card used for receiving radio signals JWR2100 you a single frequency IEEE 802.11 b / g / n
wireless network card, you can only receive 2.4GHz band
the network card if you receive a wireless signal is a single frequency JWR2100 IEEE 802.11 a / b / g /wireless
network card, you can receive the 2.4GHz or 5GHz band
RJ-45 ether net network means for connecting the line length can not exceed 100m, in order to avoid non- signal or
signals unstable situation
if you want to replace an existing router, you must start from the existing network are completely disconnected
(unplug the Ethernet cable and close the existing router power supply, etc.)
and then restart the computer.
---------------------------------------------------------------------------------------