User Manual

1. Turn on the unit and select the band.
2. Adjust the volume.
3. Rotate the knob <TUN.> to your listen to your desired
program.
FM
%
DD
TT
E E
MONO
PM
AIR
FM
AM
WB
NOAANOAA
ENABLE
DISABLE
ALL
MULTIPLE
SINGLE
COUNTY
VOICE
SIREN
ZZ Z
ALERT
%
DD
TT
EE
Frequency Changes
Select AM Step 9K/10K
%
DD
TT
EE
:
05 25
9KStep
%
DD
TT
EE
:
05 25
10K Step
Auto Scan Tuning
1. Turn on the unit and select the band.
2. Press and hold the button <M+> or <M-> with the
frequency changing in the display, then release the
button, the unit is auto scan tuning the stations. When
auto tuning the strong signal, the unit will broadcast the
station.
FM
%
DD
TT
E E
MONO
PM
AIR
FM
AM
WB
NOAANOAA
ENABLE
DISABLE
ALL
MULTIPLE
SINGLE
COUNTY
VOICE
SIREN
ZZ Z
ALERT
%
DD
TT
EE
Press and Hold M+or M-
Frequency Changes
:
89 80
9 10
TUNING INTO STATIONS
In the unit off mode, press and hold the button <AM>
about 5 seconds with the step 9K or 10K appearing in
the display. Press and hold the button <AM> again to
convert between 9K and 10K.
Using the Antenna
While listening to the FM or AM programs, please
extend the telescopic antenna fully and get close to the
window to get the best reception. The unit uses an
internal, ferrit bar antenna for AM or LW. While
listening to the AM or LW programs, please rotate the
unit to get the best reception.
Manual Tuning in Stations
Direct Frequency Entry
Input FM Band Frequency
After inputting FM band number, press the <FM/AM>
button shortly to listen to FM program.
Input AM Band Frequency
First select the frequency range(MW, AM or LW), then
input the frequency number. After inputting the number,
press the <AM> button to confirm.
NOTE: While inputting the frequency number, the number "0" at the end
of the frequency can be deleted. The time between two steps is limited,
please perform quickly otherwise the inputting is invalid.
RADIO OPERATION