Use and Care Manual

6
V. INSTRUCTION
 Note:
 Position your Cooler so that the plug is accessible.
 Keep your Cooler out of direct sunlight.
 Do not place next to heat generating appliance.
 Place the Cooler on a leveled surface that is strong enough to support the unit when it is
fully loaded. To level your Cooler, adjust the front feet located at the bottom of the unit.
 Important:
 Before connecting the unit to a power source, allow it stand upright for approximately 3
hours. This will reduce the possibility of any system malfunctions which may have occurred
from handing during transportation.
 When positioning the Cooler, 6 inches of space at the back and 10 inches of space both
sides are suggested. Do not put any objects on top of the unit which may block the air
circulation.
 Power Connection:
 This Cooler should be properly grounded for your safety and to minimize the possibility of
electrical shock, the power cord of this unit is equipped with a 3-pin plug which fits with 3-pin
wall outlets.
 Never cut or remove the ground wire from the supplied power cord.
 The use of extension cords is not recommended.
 This unit requires a standard 110V-60Hz electrical outlet with a 3-pin plug.
 The cord should be secured behind the Cooler. Also, to prevent accidental injury, do not
expose or dangle the cord
VI.VENTILATION
 Do not install the Cooler in a closed cabinet without proper ventilation.
 Please leave at least 6 inches distance between the wall and the Cooler.
 Do not remove the feet of the Cooler. Keep at least 50mm of ground clearance.
VII.CLEANING
 UNPLUG the Appliance, and remove all items including shelves.
 Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
 Wash the shelves with a mild detergent solution.
 Wash the outside cabinet with warm water and mild detergent. Rinse well and wipe dry with a
clean soft cloth.