User's Guide

KALI AUDIO MVBT User’s Guide
7
Pairing Button
Press and hold the Kali logo for 2 seconds to enable pairing mode. The LED
around the logo will ash quickly to indicate that you are in pairing mode. With
pairing mode enabled, you should be able to nd the MVBT on your device (la-
beled “Kali MVBT”) and pair to it.
If the MVBT is not paired, but not in pairing mode, the LED around the logo will
ash slowly. To enter pairing mode, either press and hold the Kali logo for 2 sec-
onds, or restart the MVBT by unplugging the unit and plugging it back in.
3.5mm (AUX) Input
Use the 3.5mm input for older devices that do not have Bluetooth, in situations
where wireless interference makes Bluetooth unusable, or if you prefer using a
physical connection.
Inputs, Outputs, and Controls
5V DC Power input
Connect the included wall wart to this input. This is the only way of turning the
MVBT on or off.
XLR Outputs
Use the XLR Outputs to send signal to a pair of speakers, a mixer, or an interface.
Because XLR is a balanced connection, you needn’t worry about adding more
noise to the signal. Either the XLR or TRS outputs may be used according to your
preference
TRS Outputs
Use the TRS Outputs to send signal to a pair of speakers, a mixer, or an interface.
Because TRS is a balanced connection, you needn’t worry about adding more
noise to the signal. Either the XLR or TRS outputs may be used according to your
LED Array
The LED Array indicates the current volume. More LEDs will illuminate from left to
right as volume is turned up.
Volume Control
Control output volume with the large, weighted knob. This volume controller does
not control the volume from your device, so you can pass the highest possible
quality audio at all times.