User's Manual

KALI AUDIO IN-Series 2nd Wave Studio Monitor User’s Guide

First Time Setup

• Before you plug the speaker in, make sure that the power switch is in the OFF position

• Plug the speaker in

• Connect audio cables

◊ If you’re connecting RCA, make sure that dip switch #8 is switched UP to the ON posi-

tion

◊ If you’re connecting XLR or TRS, make sure that dup switch #8 is switched DOWN to the

OFF position

◊ Do not connect more than one audio cable to the speaker at the same time.

• Turn the volume knob counter clockwise as far as it will go

• Turn the speaker on

• Start playing material from your playback device at a low volume

• Slowly turn the volume knob clockwise to the center detente, -0 dB position. Make sure you hear what

you’re playing

• Set the boundary EQ for your application. Refer to page 12 above.

• Repeat these steps for every speaker you’re using.

• Sit in your listening position, and turn the volume up on your playback device to the desired level

• Enjoy your new studio monitors!

Climate Considerations

The IN-series studio monitor’s enclosure is made of MDF wood and wrapped in vinyl, which is sensitive to

heat and humidity. The product should be kept and used in a climate-controlled environment. Exposure to

direct sunlight, moisture, or consistent humidity above 65% may cause the vinyl to peel and wrinkle. Addi-

tionally, do not set anything on top of the speakers, as this can cause discoloration or warping of the vinyl.

This is not covered under warranty.