User's Manual

KALI AUDIO WS-12 Studio/Live Subwoofer User’s Guide 11
Dip Switches
Like the LP-Series Studio Monitors, the WS-12 features easy-to-use dip switches on the
back that help you configure it to your specific application. Note that each set of switch-
es is completely independent of one another, so any adjustments you make to one set of
switches will not affect any other set of switches.
Switches 1-4: Crossover
These switches control a low-pass filter that passes signal to the subwoofer, and a high-
pass filter that passes signal out through the XLR outputs. If you’re using more than 2 full-
range speakers, it is recommended to set the crossover to “External” and use an external
processor and crossover.
Position 1: LP-6
The subwoofer is connected to a stereo pair of Kali Audio LP-6 Studio Monitors. For best
results, turn volume control on the subwoofer and both monitors to the center detente.
As long as the subwoofer is roughly the same distance to the listener as the monitors, the
volume of the subwoofer will be matched to the monitors.
Switch 1: DOWN
Switch 2: DOWN
Switch 3: DOWN
Switch 4: DOWN
Position 2: LP-8/IN-8
The subwoofer is connected to a stereo pair of Kali Audio LP-8 or IN-8 Studio Monitors.
For best results, turn volume control on the subwoofer and both monitors to the center
detente. As long as the subwoofer is roughly the same distance to the listener as the
monitors, the volume of the subwoofer will be matched to the monitors.
Switch 1: UP
Switch 2: DOWN
Switch 3: DOWN
Switch 4: DOWN
Position 9: LFE
The subwoofer is being used as a dedicated subwoofer for Low Frequency Effects (LFE)
while mixing for film.
Switch 1: DOWN
Switch 2: DOWN
Switch 3: DOWN
Switch 4: UP