Specification Sheet
FEATURES
● Brass valve body
● Pressure-balancing diaphragm design valve
● One-piece diaphragm cartridge design for ease of
maintenance
● Mixing valve cycles from “cold” to “hot”
● High-temperature limit setting for added safety
Pressure-Balancing Valve
SPECIFIED MODEL
Model Description Finishes
P19310-WS Pressure-Balancing Valve, with screwdriver stops NA
Optional Accessory
10350-NA Universal Rite-Temp® Valve Deep Rough-In NA
P19310-WS
INSTALLATION NOTES
All dimensions are nominal.
Install this product according to the installation guide.
Avoid cross-fl ow conditions. Do not install shut-off device on either valve outlet.
Cap the shower outlet if deck-mount spout, diverter, or handshower is connected to the spout outlet.
Install straight pipe or tube drop of 7” (178 mm) to 18” (457 mm) with single elbow between the valve and wall-mount spout.
For fi nished walls greater than 3/4” (19 mm) and less than 1-1/2” (38 mm), install support(s) 2” (51 mm) from the stud face.
For fi nished walls greater than 1-1/2” (38 mm), install support(s) 3” (76 mm) from the face of the fi nished wall.
Cutout for finished walls
less than 3/4" (19 mm)
Cutout for finished walls
greater than 3/4" (19 mm)
Ø 5" (127 mm)
7/8" (22 mm)
Ø 4-1/2" (114 mm)
Ø 4" (102 mm)
Cut Line
Cut Line
Ø 1"
(25 mm)
Outlet Port
1/2"-14 NPT and 5/8" ID
for 1/2" Nominal
Copper Tubing
Inlet Port
1/2"-14 NPT and 5/8" ID
for 1/2" Nominal
Copper Tubing
Min Finished Wall
Max Finished Wall
1-15/16"
(49 mm)
1-15/16"
(49 mm)
2-3/4"
(70 mm)
3-1/2"
(89 mm)
Outlet Port
9/16"
(14 mm)
5-7/8" (149 mm)
2-3/16"
(56 mm)
2-15/16"
(75 mm)
We reserve the right to make revisions without notice in the design of products or in packaging unless this right has specifi cally been waived at the time the order is accepted.
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
1260937-4-B
©2015 KALLISTA
CODES/STANDARDS APPLICABLE
Specifi ed model meets or exceeds the following:
● ASME A112.18.1/CSA B125.1
● ASSE 1016