Installation Guide

1. Install the Drain Body

Install the pop-up drain to the lavatory according to the

manufacturer’s instructions.

Remove the inlet nut from the bottle trap body. Ensure the seal is

inside the inlet nut.

NOTICE: To ensure a proper compression ﬁt, the tailpiece must be

inserted at least 1” (2.5 cm) inside the inlet nut.

With the threads facing down, slide the inlet nut with seal onto

the tailpiece.

Place the bottle trap body around the tailpiece, then hand-tighten

the inlet nut until the nut is ﬂush against the bottle trap body. If

necessary, use a clean strap wrench to assist you.

NOTE: The supplied extension tube is 12” (30.5 cm) in length.

Measure the length from the drain stub-out to the inner-most

edge of the outlet nut. If the measured length is less than 12”

(30.5 cm), cut the length of the pipe using a hack saw. Be careful

not to damage the ﬁnish. If the measured length is more than 12”

(30.5 cm), a pipe of appropriate length may be purchased

separately.

Remove the outlet nut from the bottle trap body. Ensure the seal

and ring is inside the outlet nut.

NOTICE: To ensure a proper compression ﬁt, the pipe must be

inserted at least 1” (2.5 cm) inside the outlet nut.

To Lavatory

Pipe

Inlet Nut

Drain Stub-Out

Flange

Tailpiece

Bottle Trap Body

Seal

Finished

Wall

Outlet

Nut

Seal

Ring

Measure.

Kallista 3 1075595-2-A