Installation Guide

INSTALLATION INSTRUCTIONS
Kallista Contemporary Toilet Supply Line
& Kallista Traditional Toilet Supply Line
1096758_2_A
2 of 2
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
THANK YOU FOR CHOOSING KALLISTA
We appreciate your commitment to Kallista quality products. Please take a moment to review this manual be-
fore you install your Kallista product. If you encounter any installation or performance problems, please do not
hesitate to contact us at the phone number listed at the bottom of the page.
TOOLS
Adjustable
Wrench
Thread
Sealant
Strap
Wrench
BEFORE YOU BEGIN
CAUTION: Risk of product damage. Do not kink or cause damage to the supply tube during installation.
Observe all local plumbing and building codes. 
Turn off the main water supplies. 
Kallista reserves the right to make revisions in the design of products without notice, as specied in the 
Price Book.
INSTALL THE SUPPLY AND STOP1.
Water
Supply
Escutcheon
Shroud
Supply Tube
Apply thread
sealant tape
Nut
Water Outlet
Nut from Toilet
Valve
Wrap thread sealant tape around the threads of the valve body as- 
sembly.
Slip the escutcheon over the threaded end of the valve body assem- 
bly. Thread the valve body assembly into the water supply.
Tighten with a clean strap wrench, making sure the water outlet on the 
body assembly is facing straight up.
Remove the shroud from the water outlet and set aside. 
Determine the length of the supply tube by measuring from the top of 
the water outlet to the bottom of the toilet valve, and add 3/4”. Care-
fully cut the supply tube to the required length, being careful not to
compress the tube. Remove any burrs from the cut end.
Remove the nut from the toilet valve and slide it onto the supply tube. 
Slide the shroud onto the supply tube.
Loosen the nut on the valve body assembly outlet and insert the plain 
end of the supply tube. Tighten the nut with a wrench.
Align the top of the supply tube with the bottom of the toilet valve (the supply tube can be bent slightly), and 
thread the toilet valve nut onto the toilet valve.
Turn on the main water supply. Turn the valve handle to the left. Check for leaks and repair as necessary. 
Slide the shroud over the valve body assembly outlet. 
Slide the escutcheon so that it meets the wall. Apply a bead of silicone sealant or caulk if desired. 