Installation Guide

INSTALLATION INSTRUCTIONS
Contemporary Basin Set Supply Line
& Traditional Basin Set Supply Line
1096759_2_A
2 of 3
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
THANK YOU FOR CHOOSING KALLISTA
We appreciate your commitment to Kallista quality products. Please take a moment to review this manual be-
fore you install your Kallista product. If you encounter any installation or performance problems, please do not
hesitate to contact us at the phone number listed at the bottom of the page.
TOOLS
Adjustable
Wrench
Thread
Sealant
Strap
Wrench
BEFORE YOU BEGIN
CAUTION: Risk of product damage. Do not kink or cause damage to the supply tube during installation.
Observe all local plumbing and building codes. 
Turn off the main water supplies. 
Kallista reserves the right to make revisions in the design of products without notice, as specied in the 
Price Book.
INSTALL THE SUPPLY AND STOP1.
Water
Supply
Supply Nut
Supply Tube
Shroud
Nut
Outlet
Escutcheon
Apply thread
sealant tape
Quick-connect
Valve Adaptor
Wrap thread sealant tape around the threads of the valve body 
assembly.
Slip the escutcheon over the threaded end of the valve body as- 
sembly. Thread the valve body assembly into the cold water supply.
Tighten with a clean strap wrench, making sure the water outlet on 
the body assembly is facing straight up.
Remove the shroud from the water outlet and set aside. 
If using the quick-connect valve adaptor, remove the supply hose 
from the valve and install the quick-connect valve adaptor into the
quick-connect valve at this time.
Determine the length of the supply tube by measuring from the top 
of the water outlet to the bottom of the quick-connect valve adap-
tor, or faucet supply valve, and add 3/4”. Carefully cut the supply
tube to the required length, being careful not to compress the tube.
Remove any burrs from the cut end.
Slide the supply nut and shroud onto the supply tube. 
Loosen the nut on the valve body assembly outlet and insert the 
plain end of the supply tube. Tighten the nut with a wrench. Allow
the shroud to slide down over the nut.