Thermostatic Trim INSTALLATION INSTRUCTIONS P22152, P22162, P22762, P22852 P22152-BL, P22152-LV P22152-CR P22162-CR P22162-BL, P22162-LV P22762-XX, P22762-CC, P22762-BC, P22762-GC P22762-LV P22852-XX 1085243-2-A Page 1 of 4 Questions? Problems? For additional assistance, please contact Kallista's Customer Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
Thermostatic Trim INSTALLATION INSTRUCTIONS P22152, P22162, P22762, P22852 THANK YOU FOR CHOOSING KALLISTA We appreciate your commitment to Kallista quality products. Please take a moment to review this manual before you install your Kallista product. If you encounter any installation or performance problems, please don't hesitate to contact us at the phone number listed at the bottom of the page. BEFORE YOU BEGIN Prior to installation, unpack the thermostatic trim and inspect it for damage.
Thermostatic Trim INSTALLATION INSTRUCTIONS P22152, P22162, P22762, P22852 1. INSTALL THE VALVE STEM ADAPTER NOTE: Check the finished wall surface as related to the graphics on the plaster guard. Remove and discard the plaster guard. Select the correct length valve stem adapter and valve stem adapter screw for your application. Refer to the information stamped on the plaster guard to verify the wall thickness. For a thin wall - 3/16" (5 mm) to 9/16" (1.
Thermostatic Trim INSTALLATION INSTRUCTIONS P22152, P22162, P22762, P22852 2. INSTALL THE TRIM (cont’d.) Visually inspect the front plate assembly to ensure that the foam seal is completely covering the wall opening. If not, stop the installation and repair the wall opening. Visually inspect for proper foam seal Ensure that the seal is installed in the back of the escutcheon. Place the escutcheon over the front plate assembly.