Installation Guide

INSTALLATION INSTRUCTIONS
TurnSpray™ Bodyspray
1118174_2_B
3 of 4
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
INSTALL THE SUPPLY PIPING1.
Single Bodyspray Installation
Nipple
Multiple Bodyspray Installation
Pressure Balancing Loop
Nipple
Water Supply
Multiple Bodyspray Installations
Route the water supply lines. 
If installing more than one bodyspray off the same supply line, construct a pressure balancing loop. Locate 
a tee along the loop at each bodyspray installation location.
Do not strap the pipes at this time. 
Single Bodyspray Installations
Route the water supply line. 
Install an elbow to the end of the supply pipe at the bodyspray installation location. 
All Installations
Temporarily install a nipple to each tee/elbow. Do not use any sealant. 
Verify that the nipple(s) will extend 1/2” beyond the nished wall when fully tightened. 
Install appropriate backing and strap the pipes. 
Finish the wall 
INSTALL THE PIPE NIPPLE2.
Finished Wall
1/2”
(1.3 cm)
1/2” Pipe Nipple
Apply sealant tape.
1-1/8”
(2.9 cm)
Verify that the hole in the nished wall is 1-1/8” in diameter. 
Install a 1/2″ NPT pipe nipple so that it extends 1/2” beyond the nished wall when fully tightened. 
Run water through the system to ush out dirt and debris. 
Apply sealant tape around the exposed threads of the pipe nipple. 