Installation Guide

INSTALLATION INSTRUCTIONS
TurnSpray™ Bodyspray
1118174_2_B
4 of 4
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
INSTALL THE BODYSPRAY3.
Wrench
(Included)
Nipple
Escutcheon
Bodyspray Head
Turn the escutcheon until it is fully retracted into the ball joint. 
Using the included wrench, turn the bodyspray onto the nipple until it is snug. 
NOTE: A 1/2” driver can be used with the included wrench to increase leverage.
Turn the bodyspray head clockwise to the fully closed position. 
NOTE: The valve only requires about 50° of travel to close, the bodyspray head will continue to rotate even
after the valve is closed.
Turn on the main water supply and the water supply to the bodyspray. Check for leaks. Repair as needed. 
Turn the bodyspray head counter-clockwise to open the valve and turn on the bodyspray. Check for leaks. 
Repair as needed.
Turn the escutcheon until it is snug against the nished wall. A strap wrench can be used, if desired. 