Care and Cleaning Guide

CARE & CLEANING INSTRUCTIONS
CARE OF NICKEL SILVER AND CHROME
Water conditions vary across the country. Chemicals and minerals in the water and air can
combine to have an adverse effect on the finish of your fixtures. In addition, nickel silver shares
similar characteristics and appearance with sterling silver and a slight tarnishing is normal.
We recommend that you rinse away any traces of soap and gently dry with a clean soft cloth
after each use. This care will maintain the high gloss finish of your Kallista fixtures and avoid
water spotting.
An occasional application of a pure, non-abrasive wax is helpful in preventing water spot build-
up and light buffing with a soft cloth will produce a high luster.
To remove water spots and tarnishing, apply a small amount of Simichrome Polish
®
to the fixture;
rub briskly; wipe clean with a clean, soft cloth. Simichrome also contains a protective film to
enhance maintenance.
NOTE: DO NOT USE ABRASIVE CLEANERS OR SOLVENTS
CARE OF BRUSHED NICKEL, ANTIQUE COPPER, GUNMETAL, BRONZE, ANTIQUE SILVER, BLACK NICKEL,
WEATHERED BRONZE AND MATTE GOLD PLATED FIXTURES
While Kallista luxury finishes plate to a greater thickness and higher quality than usual, they are
still jewelry finishes and require special maintenance.
Water conditions vary across the country. Chemicals and minerals in the water and air can
combine to have an adverse effect on the finish of your fixtures.
We recommend that you rinse away any traces of soap and gently dry with a clean soft cloth
after each use. This care will maintain the high gloss finish of your Kallista fixtures and avoid
water spotting.
An occasional application of a pure, non-abrasive wax is helpful in preventing water spot build-
up and light buffing with a soft cloth will produce a high luster. Do not allow materials such as
toothpaste, nail polish remover, or caustic drain cleaners to remain on the surface.
Over time, with constant cleaning, the surface of your fixture may begin to show wear. The wear
will take the form of faint lines in the highly polished surface.
NOTE: DO NOT USE ABRASIVE CLEANERS OR SOLVENTS

Summary of content (13 pages)