Deck Mount Bath Set INSTALLATION INSTRUCTIONS 1080602-2-A Page 1 of 6 P24403, P24404, P24405 P24403-CR P24403-LV P24404-CR P24404-LV P24405 -CR P24405 -LV Questions? Problems? For additional assistance, please contact Kallista's Customer Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
Deck Mount Bath Set INSTALLATION INSTRUCTIONS P24403, P24404, P24405 THANK YOU FOR CHOOSING KALLISTA We appreciate your commitment to Kallista quality faucets. Please take a moment to review this manual before you install your Kallista faucet. If you encounter any installation or performance problems, please don't hesitate to contact us at the phone number listed at the bottom of the page. BEFORE YOU BEGIN INSTALLER INFORMATION Please read all instructions before you begin.
Deck Mount Bath Set INSTALLATION INSTRUCTIONS P24403, P24404, P24405 1. REMOVE PIPE PLUG 3/8” Pipe Plug CLOSE COLD WARNING: Risk of personal injury. Lines will be pressurized. Do not lean over pipe plug when turning or removing the plug. CLOSE HOT Ensure that the valves are closed (cold - fully counterclockwise, hot - fully clockwise). Turn off the main water supply. Wrap a towel around the pipe plug to prevent water spray. Important! Water will purge from the supply tube when you remove the plug.
Deck Mount Bath Set INSTALLATION INSTRUCTIONS P24403, P24404, P24405 2. INSTALL SPOUT (cont’d) CAUTION: Risk of product damage. Use care when installing the spout assembly to prevent damage to the O-ring seal. IMPORTANT! Keep the spout supply tube clean above the finished deck to avoid damage to the O-ring seal. Unscrew the spout escutcheon from the mounting flange and slide it up along the spout as shown, being careful not to scratch the spout.
Deck Mount Bath Set INSTALLATION INSTRUCTIONS P24403, P24404, P24405 3. INSTALL THE HANDLES Machine Screw Spline Adapter Insert a spline adapter into the female end of the stem extension. Install another spline adapter onto the male end of the stem extension. Stem Extension Spline Adapter Install the female end of the stem extension over the spline of the hot valve. Secure with the machine screw. Repeat for the cold valve.
Deck Mount Bath Set INSTALLATION INSTRUCTIONS P24403, P24404, P24405 4. COMPLETE THE INSTALLATION Ensure that both faucet handles are turned off (hot clockwise close, cold - counterclockwise close). Turn on the main water supply, and check for leaks. Repair as required. Remove the aerator assembly with the tool provided. Turn on both hot and cold valves, and run water through the spout for about a minute to remove any debris. Check for leaks. Turn off both hot and cold valves.